Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am a fresh beginner in Codesys and currently working on a project based on CanOpen.
As controller and Manager I am using ifm EcomatDisplay CR1058.
As first slave I want to configure Murrelektronik Cube20S CanOpen 57104.
Unfortunatley I can't get the moduls out of pre-operational mode.
For sure it is a beginner mistake.
Hi everyone,
I am a fresh beginner in Codesys and currently working on a project based on CanOpen.
As controller and Manager I am using ifm EcomatDisplay CR1058.
As first slave I want to configure Murrelektronik Cube20S CanOpen 57104.
Unfortunatley I can't get the moduls out of pre-operational mode.
For sure it is a beginner mistake.
Anybody how can help me?
Thanks in advance!
Sebastian