Trying to connect to a EIP remote IO device and I am getting the following error messing on the status page of the device. I have tried googling it and I have found nothing.
Diag string: 'Configure encapsulation Layer...'
On the Scanner device page it says the bus is not running but I have it configured you using the ENIPScannerIOTask which seems to be correct.
What is an "encapsulation Layer"? in this context?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
You will probably need to provide more data (e.g. remote IO vendor, model type, etc), but this seems like an issue when configuring the electronic keying (i.e. Vendor ID, Device Type, Product Code, Major Revision, Minor Revision)... essentially your EDS file.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Trying to connect to a EIP remote IO device and I am getting the following error messing on the status page of the device. I have tried googling it and I have found nothing.
Diag string: 'Configure encapsulation Layer...'
On the Scanner device page it says the bus is not running but I have it configured you using the ENIPScannerIOTask which seems to be correct.
What is an "encapsulation Layer"? in this context?
@thecolonel26,
You will probably need to provide more data (e.g. remote IO vendor, model type, etc), but this seems like an issue when configuring the electronic keying (i.e. Vendor ID, Device Type, Product Code, Major Revision, Minor Revision)... essentially your EDS file.