Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi,
Is it possible to program schneider electric motion controller using codesys? Is there document explaining the steps to do? We have 5 lexium32 drives and one canOpen drive from other manufacturer. We want to have a synchronous movement of axis. Using soMachine software, we cant able to include any other manufacturer other than schneider electric in the canMotion link.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
Is it possible to program schneider electric motion controller using codesys? Is there document explaining the steps to do? We have 5 lexium32 drives and one canOpen drive from other manufacturer. We want to have a synchronous movement of axis. Using soMachine software, we cant able to include any other manufacturer other than schneider electric in the canMotion link.