When you have added a device CANBus\J1939_Manager\1939_ECU
then how to configure the device so that it can Receive some PGN(s),and Send some PGN(s).
And most important，how to configure the transport protocol？
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
When you have added a device CANBus\J1939_Manager\1939_ECU
then how to configure the device so that it can Receive some PGN(s),and Send some PGN(s).
And most important，how to configure the transport protocol？