Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am using the CODESYS Control for Linux ARM SL Demo Version but I am not able to connect my Beckhoff EtherCAT-Slave to my PLC. The status in the development system says that the EtherCAT-master is running in Demo-Mode and the slave isn´t running but there is even no data on the bus so the master isn´t running??
Is it possible that I can use the EtherCAT-Master-Demo-Version only once for 30 minutes and then it´s over or do I only need to restart the Runtime and I have another 30 Minutes for testing?
Thanks for your answers :)
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
The 30 minutes are counted from the start of the runtime with the application using EtherCAT master, so just reboot ;-)
Source: I did a trial back in 2019 for a licensed device which did not have EtherCAT license.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hey,
I am using the CODESYS Control for Linux ARM SL Demo Version but I am not able to connect my Beckhoff EtherCAT-Slave to my PLC. The status in the development system says that the EtherCAT-master is running in Demo-Mode and the slave isn´t running but there is even no data on the bus so the master isn´t running??
Is it possible that I can use the EtherCAT-Master-Demo-Version only once for 30 minutes and then it´s over or do I only need to restart the Runtime and I have another 30 Minutes for testing?
Thanks for your answers :)
The 30 minutes are counted from the start of the runtime with the application using EtherCAT master, so just reboot ;-)
Source: I did a trial back in 2019 for a licensed device which did not have EtherCAT license.
Understood. Then I can be sure that the error is not in the license but somewhere in the operating system or the internal LAN settings.
Do I have possibilities to change or adjust settings in the configuration file for the Ethernet communication?
Hi, did you solve this thing with license? I have similar issue with modbus tcp slave... I installed license for library but same again.
Hi, unfortunately not.
But I think the problem was my Ethernet driver because I was running the runtime on a custom hardware with custom Linux Kernel.