Hi all, I'm having problems using these three Fb's combined.
Running these instructions from a gcode file (angle rounding and tool radius compensation):
N20 G52 D5 N21 G41 D3
The FB SMC_ToolRadiusCorr give me the error: SMC_TRC_PLANE_CHANGE_NOT_ALLOWED
The very same code run without problems if instead of : SMC_ReadNCFile2 and SMC_NCInterpreter
I use: SMC_ReadNCFile and SMC_NCDecoder (but in this way I cannot handle subprograms).
does anyone have any suggestions? Than you
Log in to post a comment.
Hi all,
I'm having problems using these three Fb's combined.
Running these instructions from a gcode file (angle rounding and tool radius compensation):
The FB SMC_ToolRadiusCorr give me the error: SMC_TRC_PLANE_CHANGE_NOT_ALLOWED
The very same code run without problems if instead of :
SMC_ReadNCFile2 and SMC_NCInterpreter
I use:
SMC_ReadNCFile and SMC_NCDecoder (but in this way I cannot handle subprograms).
does anyone have any suggestions?
Than you
Last edit: alejho 2020-05-18