I have a problem with my Raspberry Pi 4 and Codesys.
I have a Beckhoff coupler EK1914 + EL9410 + EL7047 which I want to address with the Raspberry. This works so far but unfortunately I get problems with the motor. The PDO's are assigned correctly in my opinion, because the terminal already ran in a Beckhoff project with exactly the same motor. Have this also checked again and that fits so far.
But my main problem is that if I want to drive the motor via the "startup", I can start it but can not turn. It is set up as a modulo and if I want to turn from 0 to 360 (clockwise), nothing happens, but if I turn from 0 to 360 (counterclockwise) there is a short clack and the motor continues to turn infinitely at a slow speed without me pressing the arrows.
What can this be?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Good morning,
I have a problem with my Raspberry Pi 4 and Codesys.
I have a Beckhoff coupler EK1914 + EL9410 + EL7047 which I want to address with the Raspberry. This works so far but unfortunately I get problems with the motor. The PDO's are assigned correctly in my opinion, because the terminal already ran in a Beckhoff project with exactly the same motor. Have this also checked again and that fits so far.
But my main problem is that if I want to drive the motor via the "startup", I can start it but can not turn. It is set up as a modulo and if I want to turn from 0 to 360 (clockwise), nothing happens, but if I turn from 0 to 360 (counterclockwise) there is a short clack and the motor continues to turn infinitely at a slow speed without me pressing the arrows.
What can this be?