Hello, I would like to set up a 1734-OE2V card as a generic component and connect it to a Raspberry via a 1734-AENTR coupler.
I understood what I had to put in "config" but I did not figure out how much byte of input and output I had to assign to it ..
For an IB8 it takes 1 input byte. For an OB8 this takes 1 input bytes and 1 output byte. With these two cards I'm ok.
If any one could explain, I would be very grateful.
thank you !
Thomas.B
Log in to post a comment.
Hello, I would like to set up a 1734-OE2V card as a generic component
and connect it to a Raspberry via a 1734-AENTR coupler.
I understood what I had to put in "config"
but I did not figure out how much byte of input and output I had to assign to it ..
For an IB8 it takes 1 input byte.
For an OB8 this takes 1 input bytes and 1 output byte.
With these two cards I'm ok.
If any one could explain, I would be very grateful.
thank you !
Thomas.B