Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am new in the codesys as well as in raspberry pi development.I am trying to communicate two raspberry pi over EthernetIP protocol. One Raspi act as a master/scanner and another is device/slave. My both raspi detects and i can able to add raspi in my codesys project bt for slave i have add one generic device and gave the IP adress of second raspi.
The errors are like as shown in the attachment.
Can i used raspi as PLC/device/slave for EthernetIP communication?
Can I required stack for the EthernetIP ?
Can i get the EDS file for raspberryPi?
Is there any changes required in the raspberry pi for codesys?
And another is question is can i use arduino uno with arduino shield as a device/slave in this project?
I am new in the codesys as well as in raspberry pi development.I am trying to communicate two raspberry pi over EthernetIP protocol. One Raspi act as a master/scanner and another is device/slave. My both raspi detects and i can able to add raspi in my codesys project bt for slave i have add one generic device and gave the IP adress of second raspi.
The errors are like as shown in the attachment.
Can i used raspi as PLC/device/slave for EthernetIP communication?
Can I required stack for the EthernetIP ?
Can i get the EDS file for raspberryPi?
Is there any changes required in the raspberry pi for codesys?
And another is question is can i use arduino uno with arduino shield as a device/slave in this project?