I have Raspberry Pi connected to MCP2515. The CAN bus is terminated with a terminating resistance.
I have enabled the corresponding data overlays for Can bus. The status of the Can bus is "Running".
However, I have two situations:
1. The CANopen_Manager runs when I append it to CAN_Bus.
2. The CANopen_Manager fails as soon as I append a device. (The device fails too!) This is true with and without the actual physical device connected to the physical CAN bus.
Can somebody throw some light on this please?
Many thanks in advance!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello all,
I have Raspberry Pi connected to MCP2515. The CAN bus is terminated with a terminating resistance.
I have enabled the corresponding data overlays for Can bus. The status of the Can bus is "Running".
However, I have two situations:
1. The CANopen_Manager runs when I append it to CAN_Bus.
2. The CANopen_Manager fails as soon as I append a device. (The device fails too!) This is true with and without the actual physical device connected to the physical CAN bus.
Can somebody throw some light on this please?
Many thanks in advance!
I tested the module with Janztec.
As soon as I append the device under CANopen_Manager on Janztec, it is detected and the CANopen_Manager turns green.
I am assuming that this is something to do with Raspberry Pi.
What am I missing out on? Kindly let me know.
Thanks again!