Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have a main wago PFC200 controller connected to several wago 750-363 network interfaces. I had a problem event with the network connection of the 750-363 interface via a damaged cable. My question is after losing connection of any device, I would like to have a response to all devices and block the operation of all devices in the network, please explain how to do this I use the Ethernet / ip protocol.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I failed , but I have an idea from what I remember, each driver / network interface has outputs and inputs about the driver's state that I think can be used to check the state in the event of a failure, just write commands to stop everything.For lack of time, I did not test my theory further .
Last edit: martin84 2023-04-21
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have a main wago PFC200 controller connected to several wago 750-363 network interfaces. I had a problem event with the network connection of the 750-363 interface via a damaged cable. My question is after losing connection of any device, I would like to have a response to all devices and block the operation of all devices in the network, please explain how to do this I use the Ethernet / ip protocol.
Hi martin84,
did you find a way to your request? I need the same, can you share the solution?
Thanks
I failed , but I have an idea from what I remember, each driver / network interface has outputs and inputs about the driver's state that I think can be used to check the state in the event of a failure, just write commands to stop everything.For lack of time, I did not test my theory further .
Last edit: martin84 2023-04-21
Thanks!
Thanks!