I have a program to take a resistive input in from a fuel level sender, and do a calculation to convert to a percentage and display it on a gauge. The calculation works correctly as I can see it run in my function block, but the HMI will not connect to display the gauge live. Codesys says my gateway is not configured properly but I cannot find how to configure it so that it works. Does anyone have any tips or tricks on how to do this?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have a program to take a resistive input in from a fuel level sender, and do a calculation to convert to a percentage and display it on a gauge. The calculation works correctly as I can see it run in my function block, but the HMI will not connect to display the gauge live. Codesys says my gateway is not configured properly but I cannot find how to configure it so that it works. Does anyone have any tips or tricks on how to do this?