Hello, I have Codesys HMI visualization on PC with license. There are 13 datasources from remote plcs. It is connected over wireguard. I also program it remotely over wireguard net.
I have problem with visualization that it stuck once or twice a day. Visualization don´t draw all pictures and isn´t possible click on buttons. Also when I want connect over Codesys firstly I see device on network, but when I try to connent, isn´t possible and device than hides from network. When I manually close application over VNC and start again, it run good again, but connecting from Codesys is only possible when I restart HMI PC.
How can I find a problem? Is there on PC any logs with problem report? Application LOG in Codesys is cleared by restart.
Thanks
The HMI should write a log file.
If not, you can enable file logging in your CODESYSHMI.cfg in the section "CmpLog"
Just remove all ";" and you should be good (just need Logger0)
Best regards,
Marcel
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello, I have Codesys HMI visualization on PC with license. There are 13 datasources from remote plcs. It is connected over wireguard. I also program it remotely over wireguard net.
I have problem with visualization that it stuck once or twice a day. Visualization don´t draw all pictures and isn´t possible click on buttons. Also when I want connect over Codesys firstly I see device on network, but when I try to connent, isn´t possible and device than hides from network. When I manually close application over VNC and start again, it run good again, but connecting from Codesys is only possible when I restart HMI PC.
How can I find a problem? Is there on PC any logs with problem report? Application LOG in Codesys is cleared by restart.
Thanks
The HMI should write a log file.
If not, you can enable file logging in your CODESYSHMI.cfg in the section "CmpLog"
Just remove all ";" and you should be good (just need Logger0)
Best regards,
Marcel