Hi I was trying to connect my micro 800 using ethernet IP with my RPi running codesys. In the CIP GENERIC message section on the micro 800 side I had to enter port number and IP address of my RPI. I couldnt figure out a value for a port number i tried 1217,11740 which shows on my communication settings . I tried 0,1,2,3,4 none of these seem to work. If you have come across this problem before could you please give me a hand thank you Joel Simon
Hi I was trying to use raspberry Pi as an ethernet ip adapter to my micro 800 PLC. While I was setting up the MSG_CIPGEN FUCTION . I had to enter a port number along with my IP address for example. '1217,192.168.1.18'. I found a port number value at my device communication settings this was 1217. This doesnt seems to work I got an error to check the port number. I was actually using a micro 800 simulator. I should be able to simulate ethernet IP communication using this method. For some reason this...
hi did you get it working ? I was trying to use raspberry Pi as an ethernet ip adapter to my micro 800 PLC. While I was setting up the MSG_CIPGEN FUCTION . I had to enter a port number along with my IP address for example. '1217,192.168.1.18'. I found a port number value at my device communication settings this was 1217. This doesnt seems to work I got an error to check the port number. I was actually using a micro 800 simulator. I should be able to simulate ethernet IP communication using this method....
Hi I was trying to use raspberry Pi as an ethernet ip adapter to my micro 800 PLC. While I was setting up the MSG_CIPGEN FUCTION . I had to enter a port number along with my IP address for example. '1217,192.168.1.18'. I found a port number value at my device communication settings this was 1217. This doesnt seems to work I got an error to check the port number. I was actually using a micro 800 simulator. I should be able to simulate ethernet IP communication using this method. For some reason this...
Hi I was trying to use raspberry Pi as an ethernet ip adapter to my micro 800 PLC. While I was setting up the MSG_CIPGEN FUCTION . I had to enter a port number along with my IP address for example. '1217,192.168.1.18'. I found a port number value at my device communication settings this was 1217. This doesnt seems to work I got an error to check the port number. I was actually using a micro 800 simulator. I should be able to simulate ethernet IP communication using this method. For some reason this...