Activity for manueldiasm

  • manueldiasm manueldiasm posted a comment on discussion Runtime 🇬🇧

    Hi, thank you for information. Let´s wait and hope that this will be the solution fo my issue.

  • manueldiasm manueldiasm posted a comment on discussion Runtime 🇬🇧

    Hi, thank you for information. Let´s wait and hope that this will be the solution fo my issue.

  • manueldiasm manueldiasm posted a comment on discussion Runtime 🇬🇧

    Hi, where do i get 4.8.0.0 runtime version ?

  • manueldiasm manueldiasm posted a comment on discussion Runtime 🇬🇧

    Hi, Thank you for your help. Your suggestion has solved the issue i also had at RPI4 but Runtime still does not run at RPI3+ !?. Any other suggestion i could try ? Meanwhile i will perform some Codesys tests at RPI4+

  • manueldiasm manueldiasm posted a comment on discussion Runtime 🇬🇧

    I have red many posts regarding this subject but after a fews hour trying i could not make Runtime running at my RPI 3+ , please help ? The error i get is ; Desired=Unknown/Install/Remove/Purge/Hold | Status=Not/Inst/Conf-files/Unpacked/halF-conf/Half-inst/trig-aWait/Trig-pend |/ Err?=(none)/Reinst-required (Status,Err: uppercase=bad) ||/ Name Version Architecture Description

  • manueldiasm manueldiasm posted a comment on discussion Deutsch 🇩🇪

    What about MQTT ? MQTT is included at standard package for Raspberry ?

  • manueldiasm manueldiasm posted a comment on discussion Runtime

    It´s working well with CCW now. Thank you for your wise advice.

  • manueldiasm manueldiasm posted a comment on discussion Runtime

    Thanks, but i have already tried all type of Modbus Function with Codesys and even i tried to use a PLC from Siemens insetad of Micro820 but no success so far. Codesys as a slave seems to work fine but not as a master. 😟 I am using a Pi 3+.

  • manueldiasm manueldiasm posted a comment on discussion Runtime

    The Modbus Tool that communicates fine with CCW does not communicate with Codesys as a Master . Any tip ? When i use the same tool being Codesys the slave the communication is fine. Help ?

  • manueldiasm manueldiasm posted a comment on discussion Runtime

    In CCW the mapping should be ok because using a Modbus tool i can read register and coil values as you can see in the attachments .

  • manueldiasm manueldiasm posted a comment on discussion Runtime

    I am trying to communicate by Modbus TCP being Codesys the master to a Micro 820 from Rockwell automation but i get the error " Slave does not support this register offset ". Any help to solve this issue ? Regards, MDias

  • manueldiasm manueldiasm posted a comment on discussion Runtime

    I am trying to communicate by Modbus TCP being Codesys the master to a Micro 820 from Rockwell automation but i get the error " Slave does not support this register offset ". Any help to solve this issue ? Regards, MDias

1