Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have red many posts regarding this subject but after a fews hour trying i could not make Runtime running at my RPI 3+ , please help ? The error i get is ;
Desired=Unknown/Install/Remove/Purge/Hold
| Status=Not/Inst/Conf-files/Unpacked/halF-conf/Half-inst/trig-aWait/Trig-pend
|/ Err?=(none)/Reinst-required (Status,Err: uppercase=bad)
||/ Name Version Architecture Description
Thank you for your help. Your suggestion has solved the issue i also had at RPI4 but Runtime still does not run at RPI3+ !?. Any other suggestion i could try ?
Meanwhile i will perform some Codesys tests at RPI4+
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I had the same problem than you with an older Version of Raspi 4. The workaround fixed the problem.
I also got the information that the runtime 4.8.0.0 will be released within next week: https://de.codesys.com/das-system/codesys-release-plan.html
Hope that works for you. Good luck
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have red many posts regarding this subject but after a fews hour trying i could not make Runtime running at my RPI 3+ , please help ? The error i get is ;
Desired=Unknown/Install/Remove/Purge/Hold
| Status=Not/Inst/Conf-files/Unpacked/halF-conf/Half-inst/trig-aWait/Trig-pend
|/ Err?=(none)/Reinst-required (Status,Err: uppercase=bad)
||/ Name Version Architecture Description
Hi,
not 100% sure, but I guess this happens only in case you ugrade an existing Bullseye to current version by sudo apt-get upgrade,
see here:
https://forums.raspberrypi.com/viewtopic.php?t=349291
the solution/workaroundn is:
1. Use a new flashed Bullseye -> February release
2. or add in
/boot/config.txt
arm_64bit=0
and reboot
Hi,
Thank you for your help. Your suggestion has solved the issue i also had at RPI4 but Runtime still does not run at RPI3+ !?. Any other suggestion i could try ?
Meanwhile i will perform some Codesys tests at RPI4+
for PI4 you need 4.8.0.0 runtime version in case it is the new hardware revision.
Last edit: eschwellinger 2023-03-29
Hi,
where do i get 4.8.0.0 runtime version ?
Hi,
I had the same problem than you with an older Version of Raspi 4. The workaround fixed the problem.
I also got the information that the runtime 4.8.0.0 will be released within next week:
https://de.codesys.com/das-system/codesys-release-plan.html
Hope that works for you. Good luck
Hi, thank you for information. Let´s wait and hope that this will be the solution fo my issue.
Hi, thank you for information. Let´s wait and hope that this will be the solution fo my issue.