I put my CodeSys project aside and used another PLC for the project, so that I can't tell. When using the PFC PLC in some future project I will try again...
Thanks for the info. Do you already know when these will be available?
Ok, nevermind. I was suspecting the wrong device to be the problem. My PLC PFC200 is not compatible with SoftMotion. In case someone runs into the same error...
Ich war letzte Woche an dem gleichen Punkt. Falls du noch nicht weiter gekommen bist: Schau dir in dem oben erwähnten Beispielprojekt mal die Application JSONFileExample etwas genauer an. Es ist wohl so, dass du dir mit JSONDataFactory zunächst einen JSONData Funktionsblock erstellen musst, auf den du dann per Pointer zugreifen kannst (IN_OUT deines Bausteins). Ich habe bisher nur versucht aus einem JSON String zu lesen, das Schreiben in ein File sollte aber entsprechend ähnlich funktionieren.
Thanks for the quick reply. I already got the SoftMotion license and installed it on my device. In the CodeSys homepage it says that Delta ASDA A2 is a supported device, so this should not be the problem I guess. Are there any other licenses needed? Or any other libraries?
Hi, I am facing the same problem. Due to the fact I am using a Delta ASDA-A2-E Controller, it should be capabale for SoftMotion, right? I installed SM3_Basic and SM3_Drive_ETC_Delta_ASDA_A2 libraries and the Ethercat bus is working when writing onto the ControlWord manually. But I still get this error and am not able to use any SoftMotion functions. Could you please tell me what I might be missing out on here?
Hi, I am facing the same problem. Due to the fact I am using a Delta ASDA-A2-E Controller, it should be capabale for SoftMotion, right? I installed SM3_Basic and SM3_Drive_ETC_Delta_ASDA_A2 libraries and the Ethercat bus is working when writing onto the ControlWord manually. But I still get this error and am not able to use any SoftMotion functions. Could you please tell me what I might be missing out on here?
Hi, I am facing the same problem. Due to the fact I am using a Delta ASDA-A2-E Controller, it should be capabale for SoftMotion, right? I installed SM3_Basic and SM3_Drive_ETC_Delta_ASDA_A2 libraries and the Ethercat bus is working when writing onto the ControlWord manually. But I still get this error and am not able to use any SoftMotion functions. Could you please tell me what I might be missing out on here?