Thank you for the reply. I was able to use this attribute in both of my Network Variable List Sends to clear the warnings.
You might want to try this library, https://www.wago.com/us/d/15735
I use the ifm products which have these blocks in their package. I would think Wago has something similar.
Hello, After updating from SP18 to SP19 I am receiving multiple C0564 warning messages after I compile. Does anyone know how to fix the warnings?
Have you cross referenced the variable to see if it is being written some where else? You could try an Execute block instead of a Move.
If you add any device to the CANOpen Manager it will send messages to verify the device is on the network. Do you have the Enable expert settings check box checked in the General tab? have you added any SDOs in the SDOs tab? I avoid using the CANOpen Manager and just use the CAN_Tx and CAN_Rx blocks from the library.
All your ACT values in the PID blocks are are not valid with a NaN.
I am receiving warnings for no assign warning messages after I updated my project from SP18 to SP19. How do I fix these warnings?