Hello everyone, i'm having some problems commanding AS1060 step motor with EL7041 (rev22) drive. With motor i've also the incremental encoder (05.2420.1230.0200.5009). I can correctly move the motor in "Position controller" operating mode with the internal counter. The problems start when i set the Encoder in feedback type or i change the operating mode. Does anyone have experience with these two terminals and can give me some advice of main parameters to check or change? Thanks everyone
Hello, i've a problem when i try to open a project in 2 different PC. On the pc used to devolop Project the compilation works perfectly. But in the second pc i have a lot of error during compilation. Does anyone know where the problem might be? Thank you a lot