Good afternoon. Thank you colleagues for your responsiveness and willingness to help. I've already figured it out.
I use SoftMotion Light libraries in my CodeSys 3.5 project. Activated the license. But probably not all the actions were completed. In the configuration of the axes A message that the driver is running in demo mode. Please tell me what complete actions need to be performed. Thanks
tested the servo with the SML_Drive_CAN_Generetic402 driver. Works. SM_Drive_Generetic402 does not work with the driver. How can signals be reassigned?
The second motor: EMJ-08AFB24 and servodrive PRONET-08AMF, Thank you for your desire to help
My equipment: servomotor ESTUN PRONET EMJ-08ASB24, servodrive Pronet-08AMG
Hello dear colleagues. I have an ESTUN PRONET servo. I'm trying to control via softmotion over the CANopen bus. There is no Ethercat bus in this servo model. In another project,using Ethercat , I controlled four axes. I have problems with ESTUN PRONET servos. A DSP-402 driver mismatch is likely. I would be very grateful for your help in solving this problem.
Hello dear colleagues. I have an ESTUN PRONET servo. I'm trying to control via softmotion over the CANopen bus. There is no Ethercat bus in this servo model. In another project, on another site.using Ethercat , I controlled four axes. I have problems with ESTUN PRONET servos. A DSP-402 driver mismatch is likely. I would be very grateful for your help in solving this problem.
Hello dear colleagues. I have an ESTUN PRONET servo. I'm trying to control via softmotion over the CANopen bus. There is no Ethercat bus in this servo model. In another project, on another site.using Ethercat AI, I controlled four axes. I have problems with ESTUN PRONET servos. A DSP-402 driver mismatch is likely. I would be very grateful for your help in solving this problem.