Hello, I am currently using Codesys Control RTE Softmotion V3 to control my servo-drives in CAN, EtherCAT and PROFINET IRT. I am using a PC with Windows 10 with the following boards: - PEAK-CAN PCIe board (for CAN and Softmotion); - Hilscher CifX with firmware 3.X and SysDrv3s driver (for PROFINET IRT); - Realteak standard NIC (for EtherCAT). I would like to switch to Linux (Debian), because this computer is old, slow, and outdated (Windows 11 is far from being compatible with this computer). Before...
Hello, I would like to know if there is a PROFIdrive layer in CODESYS. I am already familliar with Codesys's SoftMotion on CANOpen/EtherCAT (to control PLC Open FBs), and I need the same kind of stuff for PROFINET-IO devices; In my configuration, I have a CIFX board from Hischer to enable IRT, the SoftPLC "Codesys Control RTE V3 x64", and a servo-drive from INFRANOR that implements PROFINET / PROFIdrive (with IRT) protocol. This drive works well with the Object Technology of Tia Portal, but some...
As I said before, I already purchased and installed "CODESYS Control for Raspberry Pi MC SL" on my PI. Isn't that enough? Thanks @eschwellinger, I will take a look at these logs :)
Hello, Is this the same error I have on my PI? (see https://forge.codesys.com/forge/talk/Runtime/thread/6dde9a2175/ ) The Codesys Runtime on my PI stops after 30 minutes to a few hours without any explicit errors in the logs (only "CODESYS Control shutdown..."). Do you have similar behavior? Thanks.
Hello, I wanted to use my RPI as a Profinet Master, so I just purchased and installed "CODESYS Control for Raspberry Pi MC SL" and load my Codesys project into it. It works, but sometimes (after 1 to 3 hours) the PLC stops by itself without error in the log file (only "CODESYS Control shutdown..."). Here is the latest log after a crash (/tmp/codesyscontrol.log): 2022-07-29T08:58:36Z, 0x00000001, 1, 0, 34, CODESYS Control ready 2022-07-29T08:58:36Z, 0x00000001, 1, 0, 0, runtime licensed 2022-07-29T08:58:38Z,...
Hello, It looks like a driver issue. Did you select your NIC in the EtherCAT Master? And did you load the right Codesys driver (i.e CmpEt1000MPD) in this NIC?
Hello, You should download the missing librairies. Regards,
Hello, I am trying to test the brand new Codesys Package which adds Git support (thanks!) I've read the documentation provided with the package, but I don't know why all the "Git" menu items are disabled... (see screenshoot attached) Is this a bug? Or perhaps I missed something? I cannot clone or initialize a repos... Infos: - OS: Windows 11 Pro 21H2 - Codesys IDE v3.5 SP17 Patch 3 + (64bits) ; - Package Codesys Git v1.1.0.0 Thanks ! Regards, William