Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I use CoDeSys ver. 2.3.5.4 (Oct 18 2005). When I run my programm in "Simulation mode" and set breakpoint when workflow reachs breakpoint it marks with red as default. I can use Step Over and Step In commands.
But when I run my program on real controller (StrongARM + Nucleus OS) I can set breakpoint and workflow stops when reachs breakpoint but it does not marks with red and commands "Step over" and "Step in" are disabled.
I can't understand why!
Maybe somebody can help me? Where in RTS I can find code responsible for feedback to the CoDeSys evironment when breakpoint is reached?
Thanks for your answers!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I use CoDeSys ver. 2.3.5.4 (Oct 18 2005). When I run my programm in "Simulation mode" and set breakpoint when workflow reachs breakpoint it marks with red as default. I can use Step Over and Step In commands.
But when I run my program on real controller (StrongARM + Nucleus OS) I can set breakpoint and workflow stops when reachs breakpoint but it does not marks with red and commands "Step over" and "Step in" are disabled.
I can't understand why!
Maybe somebody can help me? Where in RTS I can find code responsible for feedback to the CoDeSys evironment when breakpoint is reached?
Thanks for your answers!
The problem you describe is an implementation problem. The responsible 3S developer will assist you with that problem.