Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
We have just received a 750-670 stepper module to integrate into a new project only to find there is no manual available. We hope to close the position loop with a 2 channel quadrature encoder (no marker) into a 750-631/000-010 incremental encoder interface. We have found the published Stepper_02.lib library and have downloaded the newest CoDeSys software required to use the module.
Any idea where to get more information on the stepper module or this type integration would be appreciated.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
We have just received a 750-670 stepper module to integrate into a new project only to find there is no manual available. We hope to close the position loop with a 2 channel quadrature encoder (no marker) into a 750-631/000-010 incremental encoder interface. We have found the published Stepper_02.lib library and have downloaded the newest CoDeSys software required to use the module.
Any idea where to get more information on the stepper module or this type integration would be appreciated.