Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Im assigning a variable called test to CAN BUS message bit.
After doing that when i call this variable in my ST code it gives me error that the variable is not assigned.
Hello All,
Im assigning a variable called test to CAN BUS message bit.
After doing that when i call this variable in my ST code it gives me error that the variable is not assigned.
'Test' is no vaild assignment target
Last edit: ealribi 2021-04-29