Hello, in a new project I want to use the PFC200-8215 as a profinet master. I struggle getting the pn_controller up and running. Besides that I want to use the ports x3 and x4 in switched mode of the PFC 200 for profinet instead of only one port.
I've tried changing a lot of settings but can't seem to figure it out, would appreciate all the help i can get, thanks!
you need to separate the interfaces (setting in the WBM) I guess. ( the use BR1 for Profinet)
In case it turns out that the performance is not enough, I would choose: https://www.wago.com/de/sps/edge-controller/p/752-8303_8000-002
and use the Wago TP 600 package from CODESYS store.
This will work and is due the fact that it is a quad-core system more usable for Profinet - I think the PFC
is ( depends on the number of Profinet slaves very quickly at the border).
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello, in a new project I want to use the PFC200-8215 as a profinet master. I struggle getting the pn_controller up and running. Besides that I want to use the ports x3 and x4 in switched mode of the PFC 200 for profinet instead of only one port.
I've tried changing a lot of settings but can't seem to figure it out, would appreciate all the help i can get, thanks!
you need to separate the interfaces (setting in the WBM) I guess. ( the use BR1 for Profinet)
In case it turns out that the performance is not enough, I would choose:
https://www.wago.com/de/sps/edge-controller/p/752-8303_8000-002
and use the Wago TP 600 package from CODESYS store.
This will work and is due the fact that it is a quad-core system more usable for Profinet - I think the PFC
is ( depends on the number of Profinet slaves very quickly at the border).