Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Can this be found?
Is the build info shown in the build output messages exposed through some compile time constant variables?
For contractual reasons, the end customer requires some documentation regarding spare capacity of the commissioned controller.
I was thinking this should be obtainable and reportable at runtime for the SCADA system to display in an info page or something.
Any clues?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Can this be found?
Is the build info shown in the build output messages exposed through some compile time constant variables?
For contractual reasons, the end customer requires some documentation regarding spare capacity of the commissioned controller.
I was thinking this should be obtainable and reportable at runtime for the SCADA system to display in an info page or something.
Any clues?