Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm having an issue with saving data to an SD card on my ac500. I'm saving to an SD card and my code is set to append the file but in reality it overwrites the first line over and over again. Apparently the project file is too large to attach so here is the link to it, https://drive.google.com/open?id=0B7EhQ ... lBpM2lJcXM m
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Anonymous
-
2016-08-23
Originally created by: scott_cunningham
Please check with the ABB documentation to verify they actually implemented the append mode. Some brands only implement read and write modes and append is not supported (uses write mode).
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I'm having an issue with saving data to an SD card on my ac500. I'm saving to an SD card and my code is set to append the file but in reality it overwrites the first line over and over again. Apparently the project file is too large to attach so here is the link to it, https://drive.google.com/open?id=0B7EhQ ... lBpM2lJcXM m
Originally created by: scott_cunningham
Please check with the ABB documentation to verify they actually implemented the append mode. Some brands only implement read and write modes and append is not supported (uses write mode).