Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
In Codesys 2.3 COM Library (SysComLibray) therisn't "sysComPurge" command to empties the input and output buffer of the serial interface (in Codesys V3 exist), how i can do the same function in codesys v2.3??
Best Regards,
Stefano Casarini
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Feedback from the CoDeSys support team to this topic:
<<
In V2.3 SysComPurge() was not available. On most systems you can close and reopen the COM port instead of this, to get the same effect. For the rx-part, you can also read all previous received data form the port.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Originally created by: Stefano.Casarini
Hello,
In Codesys 2.3 COM Library (SysComLibray) therisn't "sysComPurge" command to empties the input and output buffer of the serial interface (in Codesys V3 exist), how i can do the same function in codesys v2.3??
Best Regards,
Stefano Casarini
Stefano,
Did you ever get an answer to this? I have been looking something like this as well.
Thanks,
Doug
Originally created by: Stefano.Casarini
No i didin't
Feedback from the CoDeSys support team to this topic:
<<
In V2.3 SysComPurge() was not available. On most systems you can close and reopen the COM port instead of this, to get the same effect. For the rx-part, you can also read all previous received data form the port.