CODESYS Forge - CODESYS Forge / Talk / Engineering 🇬🇧: PFC100

PFC100

Forum: Engineering 🇬🇧

Creator: Ciprian

Created: 2016-03-09

Updated: 2017-04-04

Ciprian - 2016-03-09

Hi!

I have 2 questions?

Is there going to be a Codesys Runtime for PFC100 in the future?

What are the chances that the modules 750-650/2/3 from Wago to be supported? Even as payble addon?

Thank you!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

eschwellinger - 2016-03-11

Hi,
1) PFC100 will be available Q4 in the CODESYS Store
2) 750-650/2/3 depending on what you need, is it enough to get processdata from these modules and confguration is done by Wago-I/O-Check3?
BR
Edwin

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

craigtomas - 2017-04-04

Hi, I have a question about target for Wago PFC100. I seen in PDF supported devices also PFC100. Is it available yet?

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

eschwellinger - 2017-04-04

Hi,
3.5SP11 release (July) for sure.
BR
Edwin

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.