Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi guys,
I'm new in Codesys and I have a strange issue.
Here is my setup - I have a docker container that is made from debian:buster-slim, and inside I install "codesyscontrol_x64_linux_V3.5.16.0.deb" downloaded from Codesys store. Then I deploy the image in one virtual machine running on Debian buster too. The CPU on that machine is "Intel(R) Xeon(R) CPU E5-2603 0 @ 1.80GHz".
The problem that I have is that when I run the container (no program loaded on the PLC) it takes about 40% of the CPU (see attached file).
This is very strange because, I only run the container. No programs loaded, the plc is in stop mode.
Can anyone help with this?
If additional information is needed, I can provide it.
Hi guys,
I'm new in Codesys and I have a strange issue.
Here is my setup - I have a docker container that is made from debian:buster-slim, and inside I install "codesyscontrol_x64_linux_V3.5.16.0.deb" downloaded from Codesys store. Then I deploy the image in one virtual machine running on Debian buster too. The CPU on that machine is "Intel(R) Xeon(R) CPU E5-2603 0 @ 1.80GHz".
The problem that I have is that when I run the container (no program loaded on the PLC) it takes about 40% of the CPU (see attached file).
This is very strange because, I only run the container. No programs loaded, the plc is in stop mode.
Can anyone help with this?
If additional information is needed, I can provide it.
Best regards,
Julian