Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello guys, I am kinda new in codesys so I would like to ask you some questions. My goal is to build a sewing machine with two servo motors from Delta Electronics. The Delta Electronics employer suggested me to do it with codesys. But so far even tho I have seen couple tutorials in internet I haven't been able to do more then just turning on a light. My question is how to create a runtime file. So it would be executed right after the pc is turned on.
Thank you in advance.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello guys, I am kinda new in codesys so I would like to ask you some questions. My goal is to build a sewing machine with two servo motors from Delta Electronics. The Delta Electronics employer suggested me to do it with codesys. But so far even tho I have seen couple tutorials in internet I haven't been able to do more then just turning on a light. My question is how to create a runtime file. So it would be executed right after the pc is turned on.
Thank you in advance.