KNX-"Allgemein / Parameter"

mg0815
2020-11-17
2020-11-23
  • mg0815

    mg0815 - 2020-11-17

    Dear sirs

    I made some copies of the view of my display some time ago.
    In an older version it looks different. I am missing the line to change the parameters.
    Where they are now? What I make wrong?

    Mario

     
  • mg0815

    mg0815 - 2020-11-23

    Now I tried to reconstruct the error with an older project. (made a few months ago)
    I took the same project (originally installed with V3.5.16.1) and I opened the project once with V3.5.16.1 and once with V3.5.16.2

    see my picture.
    Sorry for pushing you, I need a solution today. I am working actually on a project with 7 controllers V3.5.16.2 and after the 5th controller I recognize this behaviour. Question: "Is it possible to downgrade to V3.15.16.1 ???"

    Maybe I make something wrong but I don't find any solution.

    Regards Mario
    +43 650 5126425

     
  • mg0815

    mg0815 - 2020-11-23

    Oh my god! You are right. I was searching for this fault already 1 day.

    THANK YOU a lot

    Mario

     

Log in to post a comment.