Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
As the title says, I am trying to communicate a PLC of IFM that uses CodeSys V3 and a raspberry PI 4 using candump (SocketCAN). Has someone try this before? Because I have tried to create a basic program on the PLC that enables the first CAN channel with a fixed bitrate and trying to read or write CAN messages and on the Raspberry side, I am just trying to send or read with the candump or cansend with the same bitrate.
I have been reading a bit about this topic and the majority of the people is using the raspberry PI with codesys and then the socket CAN to receive the messages.
Regards,
Macetaman.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello everyone!
As the title says, I am trying to communicate a PLC of IFM that uses CodeSys V3 and a raspberry PI 4 using candump (SocketCAN). Has someone try this before? Because I have tried to create a basic program on the PLC that enables the first CAN channel with a fixed bitrate and trying to read or write CAN messages and on the Raspberry side, I am just trying to send or read with the candump or cansend with the same bitrate.
I have been reading a bit about this topic and the majority of the people is using the raspberry PI with codesys and then the socket CAN to receive the messages.
Regards,
Macetaman.