I'm working on a project where I want to have the following:
WAGO 750-8212 as controller
WAGO 750-340 as device
Raspberry Pi 4 as device
All devices are on the same local network and I've set static IP-s for the devices. However in Codesys V3.5 SP18 Patch 4, I can't seem to get the Profinet controller to activate when put into run:
I'm working on a project where I want to have the following:
All devices are on the same local network and I've set static IP-s for the devices. However in Codesys V3.5 SP18 Patch 4, I can't seem to get the Profinet controller to activate when put into run:
I have the following error message(s):
WinPcap is already installed (5.1.72.1206) so this thread is to no use. https://forge.codesys.com/forge/talk/Engineering/thread/4dee464d00/
Is there anything else I can do to make this work?
seperate the ethernet interfaces (wbm) on PFC200 use the br1 on the controller
Last edit: eschwellinger 2023-02-10
Do you mean like this?
I'm still getting the same error..
Hi,
for me it works that way on br1 and with separated interfaces.
If you let CODESYS change the IP Adress you need additional:
[SysSocket]
Adapter.0.Name="br1"
Adapter.0.EnableSetIpAndMask=1
added in /etc/CODESYSControl_Usr.cfg ( then you could enable the setting 'Adjust operating system setting'