Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Greetings, i am working on a project and i a using GN-9372 plc and the controller i am using to connect the codesys tags to the HMI and ix runtime is ARTI, when i communicate with the ix runtime to show the values status the virtual tags i have created are showing the changes and working fine but for the integrated PIO values its not showing the changes, now i want to add a modbus controller to the program and i want to map the tags that i have used in the arti controller to the modbus, but i am unable to do so. need your support
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Greetings, i am working on a project and i a using GN-9372 plc and the controller i am using to connect the codesys tags to the HMI and ix runtime is ARTI, when i communicate with the ix runtime to show the values status the virtual tags i have created are showing the changes and working fine but for the integrated PIO values its not showing the changes, now i want to add a modbus controller to the program and i want to map the tags that i have used in the arti controller to the modbus, but i am unable to do so. need your support