I have a Control Techniques M751 driver that I'm controlling with a codesys-based PLC.... I want to implement a rate-limiting torque control. How could I do it??.. Is there any FB from codesys that allows me to do it?? Thank you
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
YEs..This drive supported Softmotion...
I attaced the photos...for example with this driver can i move in absolute mode but i canΒ΄t aplicated FB set Torque and the 2 FB are down the same libre SM3_Basic
I have a Control Techniques M751 driver that I'm controlling with a codesys-based PLC.... I want to implement a rate-limiting torque control. How could I do it??.. Is there any FB from codesys that allows me to do it?? Thank you
I want implement a Control torque with limit speed..Now I use the FB SMC_SetTorque and SMC_SetControllerMode and not fine work...not moving
check the documentation inside the CT library if this is supported by the Softmotion library for this drive.
YEs..This drive supported Softmotion...
I attaced the photos...for example with this driver can i move in absolute mode but i canΒ΄t aplicated FB set Torque and the 2 FB are down the same libre SM3_Basic
I atached other photo
you need to check this in the Cotrol tech specifc SoftMotion lirary in CODESYS library manager.
There is embedded a pdf inside this library.
Last edit: eschwellinger 2024-03-14
Please...can you help me???I donΒ΄t understand...Where check it that you tell me ??Where appear Pdf??? I need more support thanks
..ETC_Emerson_Unidrive