Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
a)
I want to check the acitive license via Codesys
This works for for HardWareDongel and SoftwareDongel
Whats the correct code for KNX for
CMPCODEMETER.CodeMOpen(????,6000437,0001,Result);
b)
Yesterday I used a license-number for KNX
Badly I saved before only the license for the controller (without KNX)
Then I damaged the SD card completelly (my fault)
Before it was always possible to set the licence again by using "Zusätzliche Funktionen/Lizenz wiederherstellen". But it does not work any more. I need to use an new license number.
Dear Sir or Madam
a)
I want to check the acitive license via Codesys
This works for for HardWareDongel and SoftwareDongel
Whats the correct code for KNX for
CMPCODEMETER.CodeMOpen(????,6000437,0001,Result);
b)
Yesterday I used a license-number for KNX
Badly I saved before only the license for the controller (without KNX)
Then I damaged the SD card completelly (my fault)
Before it was always possible to set the licence again by using "Zusätzliche Funktionen/Lizenz wiederherstellen". But it does not work any more. I need to use an new license number.
Regards
Mario
write to my question in CODESYS store please