Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Is there a reason why a target visualisation will not start if I am connected to the target by Remote Desktop?
If the PLC is started before I Remotely connect, it works. But if I am connected by Remote Desktop and then start the PLC the Visualisation will not start in the remote session. If I then log on locally on the target, the visualisation is there!!!
Also, is there a way to start the visualisation manually?
Thank you.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi everyone,
Is there a reason why a target visualisation will not start if I am connected to the target by Remote Desktop?
If the PLC is started before I Remotely connect, it works. But if I am connected by Remote Desktop and then start the PLC the Visualisation will not start in the remote session. If I then log on locally on the target, the visualisation is there!!!
Also, is there a way to start the visualisation manually?
Thank you.