Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi Folks,
I have CAN Device Connected so I am able to read and write data at J1939 Manager.
But unable to write the data from the PLC.
Geeting the Following error while Writing from the Ladder Logic Diagram.
Error:NO Valid Assignment Target
How we can Rsolve this Problem
Hi Folks,
I have CAN Device Connected so I am able to read and write data at J1939 Manager.
But unable to write the data from the PLC.
Geeting the Following error while Writing from the Ladder Logic Diagram.
Error:NO Valid Assignment Target
How we can Rsolve this Problem
Last edit: adarsh 2024-04-02