Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I synchronize the operation of the tripod and the conveyor.
I have a problem with the product tracking algorithm on the conveyor (PCS_1).
Sometimes I need to stop tracking a product on command without completing the operation.
I do this using MC_GroupStop.
But when I need to start moving in WCS again (using fb movelinearabsolute), I get a tripod kinematics error - SMC_CP_INVALID_ORIENTATION (Invalid orientation (non-orthonormal matrix or non-unit quaternion, internal error)).
MC_ResetGroup does not help.
What could be the problem? Has anyone encountered this?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi everyone!
I synchronize the operation of the tripod and the conveyor.
I have a problem with the product tracking algorithm on the conveyor (PCS_1).
Sometimes I need to stop tracking a product on command without completing the operation.
I do this using MC_GroupStop.
But when I need to start moving in WCS again (using fb movelinearabsolute), I get a tripod kinematics error - SMC_CP_INVALID_ORIENTATION (Invalid orientation (non-orthonormal matrix or non-unit quaternion, internal error)).
MC_ResetGroup does not help.
What could be the problem? Has anyone encountered this?