Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I tried to install the new Patch 3, but I always get an error message.
After I confirm the error, the installation continues and at the end it says, that the software was successfully installed. But if I want to open the program, it doesn't start (see attached message).
PC Info:
Win 10 x64 bit, all previous codesys versions are still starting correctly... .
Is there any workaround, to get the new version working on my pc?
Thank you in advance
Best Regards,
Kevin
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Originally created by: KevinR
Dear Community,
I tried to install the new Patch 3, but I always get an error message.
After I confirm the error, the installation continues and at the end it says, that the software was successfully installed. But if I want to open the program, it doesn't start (see attached message).
PC Info:
Win 10 x64 bit, all previous codesys versions are still starting correctly... .
Is there any workaround, to get the new version working on my pc?
Thank you in advance
Best Regards,
Kevin