I'm using Turck I/O module in my project, and I'm added it also to my project as a data source.
My problem is, that the data source manager runs only in demo mode, but I do not know why.
It causes problem, because it stops after 30 minutes.
How can I run the data source manager in normal mode?
I can not say, it solved. As I remember, in my case the reason was, that too many varibales were added into Data Source. When I've reduced the number of variables, (only the necessaries, but not all), it worked well.
I hope, it helps.
Regards
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Dear All,
I'm using Turck I/O module in my project, and I'm added it also to my project as a data source.
My problem is, that the data source manager runs only in demo mode, but I do not know why.
It causes problem, because it stops after 30 minutes.
How can I run the data source manager in normal mode?
Thank You in advance!
\Hi, did you solve this? I have similar issue with modbus tcp slave...
Hello,
I can not say, it solved. As I remember, in my case the reason was, that too many varibales were added into Data Source. When I've reduced the number of variables, (only the necessaries, but not all), it worked well.
I hope, it helps.
Regards
Thanks for answer. But I don't have too many variables.
Regards