Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello all,
Right now i try to create project where i use PLC Berghoff ECC 2100 Slim and Stepmotor with Encoder - Nema 23 - 04- CL.
Link to step motor: https://joy-it.net/en/products/NEMA23-04CL
This step motor has a RS-232 port and PLC has it too, so i think that communication is posible, but unfortunatelly i am not sure how should i do it in CodeSys.
Does anyone try to do simillar connection?
Have anyone communication protocol or can somebody sugest specification which help me to create this protocol in CodeSys?
Thank you in advane for help in this matter.
Best Regards,
Szymon/Simon
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello all,
Right now i try to create project where i use PLC Berghoff ECC 2100 Slim and Stepmotor with Encoder - Nema 23 - 04- CL.
Link to step motor: https://joy-it.net/en/products/NEMA23-04CL
This step motor has a RS-232 port and PLC has it too, so i think that communication is posible, but unfortunatelly i am not sure how should i do it in CodeSys.
Does anyone try to do simillar connection?
Have anyone communication protocol or can somebody sugest specification which help me to create this protocol in CodeSys?
Thank you in advane for help in this matter.
Best Regards,
Szymon/Simon