I am very new to Motion in Codesys. I have linear axis and would like to setup as mm, I want to move axis and control axis in mm, mm/s. How do I do that?
I know my electronic gearing is 200000.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
you have to define how many increments of the drive correspond to one unit in your application. This is done in the Scaling/Mapping Tab in the drive editor.
I am very new to Motion in Codesys. I have linear axis and would like to setup as mm, I want to move axis and control axis in mm, mm/s. How do I do that?
I know my electronic gearing is 200000.
Hi,
you have to define how many increments of the drive correspond to one unit in your application. This is done in the Scaling/Mapping Tab in the drive editor.