CODESYS Forge - CODESYS Forge / Talk / Runtime 🇬🇧: EL6751 Canopen_Manager issue

EL6751 Canopen_Manager issue

Forum: Runtime 🇬🇧

Creator: transmin01

Created: 2023-09-12

Updated: 2023-09-12

transmin01 - 2023-09-12

Hi,
I have a Beckhoff EL6751 EtherCAT / CANopen gateway which fails on the Canbus when the CANopen_Manager is added. Currently no devices are connected to the EL6751.
If I add a device, I get the same issue.
If I add a device and connect the bus, I get the same issue.

Is there something I am doing wrong?

Regards Trevor

EL6751_1.jpg

EL6751_2.jpg

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

eschwellinger - 2023-09-12

Think just add some CANopen Slaves and end resistors - then it will work ;-)

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

transmin01 - 2023-09-12

Fixed, in the end it just required the target to be rebooted. DOH!

Regards Trevor

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.