I am currently using Codesys Control RTE Softmotion V3 to control my servo-drives in CAN, EtherCAT and PROFINET IRT.
I am using a PC with Windows 10 with the following boards:
- PEAK-CAN PCIe board (for CAN and Softmotion);
- Hilscher CifX with firmware 3.X and SysDrv3s driver (for PROFINET IRT);
- Realteak standard NIC (for EtherCAT).
I would like to switch to Linux (Debian), because this computer is old, slow, and outdated (Windows 11 is far from being compatible with this computer).
Before doing this, I would like to be sure of the compatility between my 3 boards and Codesys Control Linux SL.
Otherwize, I will stay on Windows 10 and use it in an isolated environnement.
Thanks for your advices.
Regards,
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I am currently using Codesys Control RTE Softmotion V3 to control my servo-drives in CAN, EtherCAT and PROFINET IRT.
I am using a PC with Windows 10 with the following boards:
- PEAK-CAN PCIe board (for CAN and Softmotion);
- Hilscher CifX with firmware 3.X and SysDrv3s driver (for PROFINET IRT);
- Realteak standard NIC (for EtherCAT).
I would like to switch to Linux (Debian), because this computer is old, slow, and outdated (Windows 11 is far from being compatible with this computer).
Before doing this, I would like to be sure of the compatility between my 3 boards and Codesys Control Linux SL.
Otherwize, I will stay on Windows 10 and use it in an isolated environnement.
Thanks for your advices.
Regards,