CODESYS Forge - CODESYS Forge / Talk / Runtime 🇬🇧: OPC UA Server parameters in CODESYSControl_User.cfg file

OPC UA Server parameters in CODESYSControl_User.cfg file

Forum: Runtime 🇬🇧

Creator: rossanoparis

Created: 2021-10-18

Updated: 2021-10-18

rossanoparis - 2021-10-18

Hello everibody, I 've some question related to OPC UA server configuration.

Does anyone know hot to set up CODESYSControl_User.cfg file, in order to forze OPC UA server working with one network card only ?
Is it possible to specify a list of allowed IP addresses the OPC UA server is listening to ?

I'm asking this due to the fact in case of targets which supports two or three network cards configured to use several IP address, it is necessary to force OPC UA server to use a particular network card or IP address instead of all available on target.

Thanks in advance
Regards
Rossano

Last edit: rossanoparis 2021-10-18

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

eschwellinger - 2021-10-18

I think this here should help:
https://faq.codesys.com/display/CDSFAQ/OPC+UA+Server

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- rossanoparis - 2021-10-18
  
  Thank you for the reply
  
  Would you be so kind to provide (if it exists) a link or PDF document where all parameters for the two section [CmpOPCUA], [CmpOPCUAServer] are described ?
  I'm not able to find anything about them
  
  On a single network card, multiple IP addresses could be specified.
  Is OPC UA server able to listen to a specified IP address ?
  
  Regards
  Rossano
  
  If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.