CODESYS Forge - CODESYS Forge / Talk / Runtime 🇬🇧: Connect Profinet

Connect Profinet

Forum: Runtime 🇬🇧

Creator: apakrat

Created: 2018-10-11

Updated: 2018-10-12

apakrat - 2018-10-11

Hi guys, I'm trying to connect raspberry pi 2 with Matrox camera over Profinet. I've read and followed some old topic in our forum and here i got (see the picture below). Anyone know what i did i do wrong?
Thanks!

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

apakrat - 2018-10-11

After few second it run in 0.5s then back to disable again.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

eschwellinger - 2018-10-11

Hi,
you need to adjust sendclock and reduction ratio...

BR
Edwin

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

apakrat - 2018-10-12

Hi Ed, seem like i can't adjust send clock? Do you know what happen?

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

apakrat - 2018-10-12

I can change the ratio btw.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

eschwellinger - 2018-10-12

Hi,
is Ethercat and Profinet on the same network interface?

BR
Edwin

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

apakrat - 2018-10-12

Yes Ed, is it wrong?

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

apakrat - 2018-10-12

But before i connect ethercat the problem still there.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.