Hello,

I'm traying to connect with a cognex camera with a profinet protocol. Then when I'm going to create a PN_Controler this don't start....

How can i do this, HELP!!!!!!!

Hi,
1. you need to install winpcap (winpcap.org)
2. disable the windowsfirewall
3. install the slave gsdml... for the cognex camera into the device repository in CODESYS
4. Download the project and start it ... rightclick PN controller in the device tree - scan devices
This scan should show the cam ... give station name and ip. Add it to the project by this scan dialog
Now a new download ist needed...(maybe after you have added some io varable mapping)

BR
Edwin

Edwin Schwellinger hat geschrieben:
Hi,
1. you need to install winpcap (winpcap.org)
2. disable the windowsfirewall
3. install the slave gsdml... for the cognex camera into the device repository in CODESYS
4. Download the project and start it ... rightclick PN controller in the device tree - scan devices
This scan should show the cam ... give station name and ip. Add it to the project by this scan dialog
Now a new download ist needed...(maybe after you have added some io varable mapping)
BR
Edwin

Thanks, Now I can run the profinet bus, and also i see the profinet device.

One thing more, if i want do the same project with a rapsberry pi, the equals of wincamp to raspberry, which is it?

Best regards

Hi,
no on raspberry pi nothing extra is needed... just connect to the pi, browse eth0,eth1 and set the ip of the master
download - run -scan the slaves.
BR
Edwin

Edwin Schwellinger hat geschrieben:
Hi,
no on raspberry pi nothing extra is needed... just connect to the pi, browse eth0,eth1 and set the ip of the master
download - run -scan the slaves.
BR
Edwin

Thank you!!!