Codesys Runtime not running Raspberry PI 3+

2023-03-24
2023-04-03
  • manueldiasm - 2023-03-24

    I have red many posts regarding this subject but after a fews hour trying i could not make Runtime running at my RPI 3+ , please help ? The error i get is ;

    Desired=Unknown/Install/Remove/Purge/Hold
    | Status=Not/Inst/Conf-files/Unpacked/halF-conf/Half-inst/trig-aWait/Trig-pend
    |/ Err?=(none)/Reinst-required (Status,Err: uppercase=bad)
    ||/ Name Version Architecture Description

     
  • eschwellinger

    eschwellinger - 2023-03-25

    Hi,
    not 100% sure, but I guess this happens only in case you ugrade an existing Bullseye to current version by sudo apt-get upgrade,
    see here:
    https://forums.raspberrypi.com/viewtopic.php?t=349291

    the solution/workaroundn is:
    1. Use a new flashed Bullseye -> February release
    2. or add in
    /boot/config.txt
    arm_64bit=0
    and reboot

     
  • manueldiasm - 2023-03-28

    Hi,

    Thank you for your help. Your suggestion has solved the issue i also had at RPI4 but Runtime still does not run at RPI3+ !?. Any other suggestion i could try ?

    Meanwhile i will perform some Codesys tests at RPI4+

     
  • eschwellinger

    eschwellinger - 2023-03-29

    for PI4 you need 4.8.0.0 runtime version in case it is the new hardware revision.

     

    Last edit: eschwellinger 2023-03-29
  • manueldiasm - 2023-03-31

    Hi,

    where do i get 4.8.0.0 runtime version ?

     
  • Kiwi - 2023-03-31

    Hi,
    I had the same problem than you with an older Version of Raspi 4. The workaround fixed the problem.
    I also got the information that the runtime 4.8.0.0 will be released within next week:
    https://de.codesys.com/das-system/codesys-release-plan.html
    Hope that works for you. Good luck

     
  • manueldiasm - 2023-04-03

    Hi, thank you for information. LetΒ΄s wait and hope that this will be the solution fo my issue.

     
  • manueldiasm - 2023-04-03

    Hi, thank you for information. LetΒ΄s wait and hope that this will be the solution fo my issue.

     

Log in to post a comment.